Badge-Holder Wirepas
Badge-Holder Wirepas is a wearable battery-powered mobile tag, based on new-generation chip Nordic nRF52832, with a badge-holder case able to host standard ISO/IEC 7810 cards (magnetic, RFID, NFC). Badge-Holder Wirepas firmware is based on Wirepas Mesh 2.4GHz libraries, ensuring full support of Wirepas Mesh 2.4GHz functionalities. It is designed for personnel identification and tracking. Push-button and internal accelerometer (for motion, shock and free-fall detection) allow to enable worker-safety functionalities.
Badge-Holder Wirepas is waterproof and powered by a thin non-replaceable lithium battery that guarantees a long operating life.
General features
Software: Wirepas Mesh 2.4GHz v5.x Operating modes: Non-router mode - Mobile tag (periodic or on-event transmission of identifier and location) Configuration and diagnostics: Wirepas Network Tool, Wirepas gateway APIs, MeshCube APIs Mobile tag operating states: default, motion, alarm (button, free-fall, man-down), sleep Positioning interval: 15 secs to 18 hours (configurable for each state) Positioning state-timeout: 15 secs to 18 hours (configurable for each state) Beaconing: configurable (disable, iBeacon, Safety, Quuppa Emulation Mode) Beaconing interval: 100 msec to 1 hour (configurable for each state) Beaconing power: -40, -20 to 4 dBm with 4 dB steps (configurable for each state)Radio
Version: Wirepas Mesh 2.4GHz, Bluetooth Low Energy (advertising-only) Frequency: 2.402 to 2.480 GHz Module: Nordic SoC nRF52832 (MCU and transceiver) Antenna: printed meandered planar F-antenna Antenna gain: 2dB (average) Antenna pattern: omnidirectionalBattery
Replaceable: No Model: CP224147 (800 mAh typ. capacity at 25°C) Expected life: 28 months at 5 minutes interval, 13.5 years at 6 hours interval (24/7 at ambient temperature) Operating temperature: -20°C to +60°CSensors and interfaces
Accelerometer: 3-axis linear accelerometer Button: configurable Leds: 2 (green, orange)Enclosure
Material: ABS plastic Color: white Size: 95 x 64 x 7 mm Weight: 24 gr Fastening: 2x holes for lanyard/ring/badge-clip (horizontal and vertical) Host card: ISO/IEC7810 ID-1 (85,6 x 54 x 0.76 mm) Protection: IP67Certifications
CE (EU), FCC (US, pending)